Published at Monday, November 12th 2018. by Latonya Wong in End Table.
Assembly of a coffee table is going to be exactly the same. This one's already put together we'll go ahead and show you over here now, when you get them out of the box, you're going to have most of them come all three in one box, where you get two end tables in a coffee table that are all packed Together, you'll have the legs in separate boxes and hardware packs as well. You want to make sure that you have separated the coffee table on the end table legs. The coffee table legs always going to be shorter than the end table legs. So you want to make sure you separate the coffee table on the end table legs on this one we're going to go ahead and build the end table when you pull out the hardware.
The hardware most of them are going to be separated, so you're going to have the bolts, the lock washer in a washer, and then you'll also have the tool to be able to put it together. So first thing you want to do: if you wanna make sure you put the lock washer on the shaft of the bolt first and then you put your washer on there as well, and then we do the same thing for the next one, lock washer first And then the normal washer and then we're okay to be able to put these together most sets will have either one or two bolts on each leg. Just make them pretty simple: to be able to put together just come over here. We take the leg, set it right up to it, then we go ahead and just take the bolt always start them by hand. Some of them of this one, in particular, uses an Allen key to build. Some of them might use a screwdriver always make sure you start it with hands before you start using tools that way, you're not cross threading, the bolts. We got those started, we go ahead and grab the tool. Let me just use this.
I use it long ways first, so I can easily spin it in there get it to where it's snug do the same thing at the next one and then I'll flip it around use it the other way. So I get a little bit easier to tighten them up, no need to over tighten them that way, you're not damaging it, just get it to where they're tight. Then we do the same thing for the next one. To do this on all four legs start them by hand, so you know cross thread. Then we can use the tool and get them in the rest of the way to spend the tool. So we get a little bit easier to tighten them down, get them to where they're tight don't over tighten and now we're done now.
Any content, trademark’s, or other material that might be found on the nucleosanmarino.com website that is not nucleosanmarino.com’s property remains the copyright of its respective owner/s. In no way does nucleosanmarino.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 nucleosanmarino.com. All Rights Reserved.